Introduction
Groups (0)
No groups yet
Pinned Items
Recent Activities
  • OrenDavis created a new forum post in Expert Electronics
    Can someone give me a STARTING POINT where to set the transmit and bandwidth settings using the MD-15 hand mic on the MB-1? Thanks to every one that is helping me, I know my post are a PAIN ,but I am very new to SDR.
    MERRY CHRISTMAS
    73 Oren KB6DYA
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Got my wife to help me, If all else fails R.T.F.M. I thought I had problems and I do it is me!!!!
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • OrenDavis created a new forum post in Expert Electronics
    When I select options( the 2 crossed wrenches ) and go to display page and try to change a color it locks up and the only way I can get out of it is to reboot the radio . I can not get page to go away until I reboot the radio.
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • 0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • OrenDavis created a new forum post in Expert Electronics
    when reading the manual, It states you can get line out audio on the back of the MB-1. We used a amplified speaker but could not get any audio output.
    REAR PANEL DESCRIPTION
    10) MI C - PC microphone input. Line-in.
    Connect microphones to the internal PC's MIC input or use it as a line-in input.
    H headset - Headphone jack. Line-out.
    Connect headphones or other audio devices to the output.
    does anyone have any suggestions . We tried to go into windows, every thing we tried did not work.
    we removed the rubber plug on the back of the MB-1 - is that jack even hooked up. I would like better sounding audio. Will the HDMI support audio out?
    Thank you for your time.
    Oren KB6DYA
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • OrenDavis replied to the topic MB-1 tunner in Expert Electronics
    I found the answer to all my tuner problems. I had to select antenna #1 - that is the only thing I have hooked up. When it would not tune I lookup and it was on antenna 4 - I am such a idiot. Every thing works like is suppose to. It tunes on all freaks with very little drive . My next big challenge will be how it keys my Alpha 8410 , hopefully I will not have any RFI ,I have put Fer rites on Every cord on the MB-1
    KB6DYA ( stupid ass )
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • OrenDavis created a new forum post in Expert Electronics
    How do i adjust the tuner not to be so sensitive. It goes red before the eternal auto tuner can tune the ofcd antenna. it does this even when the MB-1 auto tuner is in the by pass mode, It goes to high swr before my palstar auto tuner has a chance, it happens mostly on 10 an 17 meter and the antenna swr is less than 2.1 direct. I need the palstar auto tuner because I run a amplifier.
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • OrenDavis created a new forum post in Expert Electronics
    How long will it take to get pure signal on the MB-1. Will it be hardware or software or both?
    73 Oren KB6DYA
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • OrenDavis unlocked the badge Newbie
    Newbie
    Being part of a community. To unlock this badge, you need to register on this site.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • OrenDavis just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.